Self Defense

2022 Editors’ Choice Award Winning ~ Wilson Combat SFX9 3.25 15-Round

2022 Editors’ Choice Award Winning

Wilson Combat SFX9 3.25 15-Round

By: Dave Bahde

Wilson adds a full-size grip and more payload to the smallest of the SFX9’s

Since the SFX9’s introduction, Wilson Combat has continued to expand the model lineup, currently offering four different variations of slide/grip lengths, and the new-for-2022 SFX9 3.25 15-Round is our favorite configuration to date. Like the rest of the SFX9 lineup, the 3.25 15-Round uses the X-TAC checkering treatment around the circumference of the grip frame and as cocking serrations at the rear of the slide, as well as a Bullet Proof hammer, safety, and magazine release. The trigger is your typical Wilson Combat ultra-clean 3.5 to 4-pound pull with a medium-length curved pad. Made by Mec-Gar specifically for Wilson Combat, the flush-fit magazine (two included) holds 15-rounds, and my 18-round EDC X9 magazines fit perfectly with no over-insertion issues. A dust cover accessory rail allows attachment of a light or other accessory.

The slide profile is an angled “tri-top” design with a fixed rear and fiber-optic front sight. The top of the slide is serrated at 30 LPI to cut sight-picture glare. The barrel measures 3.25-inches long and is precision-fit to the slide with no bushing. The barrel and chamber are fluted, and the reverse muzzle crown blends perfectly with the slide and recoil system for a seamless appearance. The recoil spring, guide, and plunger are a fully captured design using dual springs.

The SXF9 3.25 15-round ships with two flush-fit (you guessed it) 15-round magazines made especially for Wilson Combat by Mec-Gar. With respect to other double-stack 1911s on the market today, these magazines are remarkable for a couple of important reasons; 1: they run absolutely flawlessly; 2: they’re affordable. Need precision ammo to go with your new precision 1911? Wilson Combat has that too.

Range Time

One might expect recoil to be a bit stout given the short barrel, but it remained very controllable — one of the hallmarks of the SFX9/EDC X9 lineup. Accuracy was also consistent with what you can expect from a Wilson Combat in general; all five-shot groups came in at under 1.50-inches at 25 yards. My best effort measured around 1.3-inches, with four of the five shots landing inside an inch using Hornady’s 115 FTX load. Wilson’s 115 grain HAP was also very accurate along with the 95 grain TAC XP loads. Standing at 10 yards, it clustered rounds using controlled pairs and stayed inside a fist’s distance with hammers. Off the truck bed at 50 yards, it stayed on the 8-round round steel pretty consistently — not bad for me using iron sights. Reliability was flawless throughout testing, which has proven to be yet another shining attribute of Bill Wilson’s SFX9/EDC X9 platform.

A Wilson Combat Concealment Proof Hammer, medium-length curved trigger, Bullet Proof Thumb Safety, Bullet Proof Magazine Release, and Countersunk Slide Stop round out the operating controls. Operation was smooth and precise. Wilson’s unique and effective X-TAC checkering pattern can be found around the entire circumference of the all-aluminum grip frame and rear cocking serrations of the slide.

Other Considerations

My personal carry for the last few years has been a standard EDC X9 with a Trijicon RMR in a Palmetto Leather holster, so it gave me a good baseline while carrying the shorter SFX9 with irons sights. Loaded with the same ammunition to the same capacity, the weight of the SFX9 was 3 ounces less than my EDC X9; not a ton, but noticeable. The full-sized grip frame of the 15-round SFX9 afforded a full purchase and solid control.

The red fiber-optic front sight on my test pistol really “popped” in all light conditions, and during my range sessions, I didn’t lose much in terms of aiming precision out to 25 yards compared to an RDS; past that, however, the RDS still shines for me.

Given the shorter dimensions, moving around the steering wheel and around obstacles in the close confines of my truck was smooth and quick. And, thanks to the full-size grip, it handled like a full-size pistol while doing so. Post-training, it was not uncommon for me to forget I was wearing this pistol — it was that comfortable for me to carry.

The slide of the 3.25-inch model maintains the signature tri-cut slide that’s serrated along its entire top to cut glare. On the back end is a fixed Concealment Battlesight and a bright-red fiber-optic sight up front. Both the barrel and chamber are fluted.

Bottom Line

My large hands do not handle small pistols well, but having used every grip size imaginable in my over three decades of training, deployment, and teaching, I’m pretty adaptable, however. While I enjoyed testing the version of this pistol with the shortened grip, the full-size grip turns it into a true fighting/carry pistol for me. Years running a 1911 makes the EDCX9 my favorite, but the flatter grip dimensions and lack of stocks tended to grow on me after a bit. I’m still not sure I would trade my EDC X9 for the SFX9, but after running this pistol for a few weeks, my affinity for the RDS on a carry pistol may have waned a bit. All in all, this is a fantastic pistol, built to Wilson Combat’s standards, and could easily last a lifetime or two in someone’s carry holster. See the double-stack line of Wilson Combat pistols at your nearest dealer or for more info. contact Wilson Combat directly at; Tel.: (800) 955-4856; Web: www.wilsoncombat.com.